Version 6.0 21 March 2010
Installation Manual 2. Installing the Device
To connect MP-11x to a PC:
1. Connect the PS/2 connector (refer to the figure below for connector pinouts) on one
end of the cable to the MP-11x RS-232 port (labeled RS-232
2. Connect the DB-9 connector at the other end of the cable to either the COM1 or COM2
RS-232 communication port on your PC.
).
Figure 2-11: PS/2 to DB-9 Adaptor Connector Pinouts
Figure 2-12: PS/2 Connector Pinouts
For information on establishing a serial communications link with MP-11x, refer to
‘Assigning an IP Address Using the CLI’ on page 41.
2.1.4.5 Connecting MP-11x to Power
The MP-11x is powered from a standard AC electrical outlet.
Warnings:
• The device must be connected only by professional service personnel.
• Ensure that the device connects to an electrical socket outlet that
provides protective earthing (grounding). Prior to connecting power, refer
to the Regulatory Information document supplied with the device.
• Use only the AC power cord supplied with the device.
To connect MP-11x to the power supply:
Connect the MP-11x power socket to a standard electrical outlet using the supplied AC
power cord.
To Next Page
Loading...
Need help?
General
