10. Click End Process to close the wizard, and then in the 'Enter Network Password'
dialog box, enter your login user name and password (described in Accessing the Web
Interface) and click OK
11. Click
; a message box appears informing you of the new CMP file.
OK
; the Web interface now becomes active and reflecting the upgraded device.
3.7.2 Loading ini and Auxiliary Files
The auxiliary files (and ini file) are dat files that can be loaded to the device to provide
enhanced device provisioning. These files are described in the table below. For detailed
information on these files, refer to the device's User's Manual
Table 3-3: Auxiliary Files Descriptions
.
File Type Description
Provisions the device’s parameters. The Web interface enables practically full
device provisioning, but customers may occasionally require new feature
configuration parameters, in which case this file is loaded.
ini
Note: Loading the ini file only provisions those parameters that are included in
the ini file. Parameters not specified in the ini
Dial Plan
file are reset to factory default
values.
Dial plan file.
Call Progress
Tones
This is a region-specific, telephone exchange-dependent file that contains the
Call Progress Tones (CPT) levels and frequencies that the device uses. The
default CPT file is: U.S.A.
Prerecorded
Tones
The dat
User Info
PRT file enhances the device's capabilities of playing a wide range of
telephone exchange tones that cannot be defined in the Call Progress Tones file.
The User Information file maps PBX extensions to IP numbers. This file can be
used to represent PBX extensions as IP phones in the global 'IP world'.
Notes:
• The current settings of parameters that are not included in the ini file are
retained (incremental
• After loading the
).
ini
• Saving an auxiliary file to flash memory may disrupt traffic on the device.
To avoid this, disable all traffic on the device, by performing a graceful
lock (refer to '
file, the device does not reset. Some files (e.g., Call
Progress Tones) are not changeable on-the-fly and require a device
reset.
Saving and Resetting the Device' 44 on page ).
• You can also use BootP to load the auxiliary files to the device (refer to
the Product Reference Manual
).
To Next Page
Loading...
Need help?
General
