Connect the pressure limiter device to a drain pipe,
kept open to the air, in a frost-free environment, and
at a continuous downward gradient.
1.1.3 Electrical connections
A disconnection device must be fitted to the
permanent pipes in accordance with installation rules.
If the power cable is damaged, it must be replaced by
the manufacturer, its after sales service or persons
with similar qualifications in order to obviate any
danger.
This appliance must not be powered through an
external switch, such as a timer, or be connected to a
circuit which is regularly switched on and off by the
electricity provider.
Install the appliance in accordance with national rules
on electrical installation.
The control panel for the appliance must remain
switched on to ensure that the impressed current
anode can operate. Failure to comply with this
instruction may cause deterioration to the water
heater tank and cancel its warranty.
Wiring diagram:
See
Wiring diagram section (Installation and Service
Manual).
Connecting the appliance to the mains:
See
Electrical connections section (Installation and
Service Manual).
Fuse type and calibre:
See
Electrical connections section (Installation and
Service Manual).
1.1.4
Website
The installation manual can also be found on our
website.
1 Safety
7734712 - v01 - 22052019 5
To Next Page
Loading...
Need help?
General
