Bernard Controls AQL Range User Manual

English
10
4.2 Installation of the Fast Connector (OPTION)
Bernard Controls provide a fast connector option for AQL actuators.
With this option, the male fast connection socket should be
connected to the actuator terminals inside the actuator. Sealing
must be done using the provided M20 cable gland.
The female fast connection socket needs to be
prepared by the customer by soldering the site
cable to the connection as indicated in the figure
below and in the wiring diagram. The pins on the
female connection socket are shown on the
adjacent figure.
!
Soldering must be done according to the provided wiring
diagram.

The outer diameter of the side cable of the actuator is
Ø13~Ø16 mm.

Bernard Controls AQL Range Specifications

General

Brand	Bernard Controls
Model	AQL Range
Category	Controller
Language	English