Bernard Controls AQL Range User Manual

English
8
3.3.2 Flange spacer (OPTION)
If the valve input rod is too long and does not allow you to mount
the actuator on the valve flange, you can mount a spacer under the
actuator.
This spacer is assembled on the flange of the AQL as shown below.
3.4 Fastening the actuator on the flange
Once the actuator is coupled with the valve, you need to fasten it
on the valve flange.
How to fasten the actuator on the valve
Screw the fasteners on the actuator through the valve flange
without fully tightening the actuator.
Turn the actuator to the maximum in the counterclockwise
direction.
Hold it in this position and tighten the actuator on the flange
using the screws.

Bernard Controls AQL Range Specifications

General

Brand	Bernard Controls
Model	AQL Range
Category	Controller
Language	English