CT-110-2 27
8 Troubleshooting and eliminating faults
For troubleshooting and reading out alarm messages,
we recommend you to connect the BEST SOFTWARE
to the SE-i1. For the respective alarm messages, the
BEST SOFTWARE also offers, apart from the help
texts with possible error causes, information on verify-
ing and eliminating errors.
For a detailed description of the monitoring functions,
the alarm list including definition of the alarm types and
the description of all LEDs, see Reference Guide
CG-110.
Resetting SE-i1
To reset the SE-i1 after a fault, the following options
are available:
• Disconnect the voltage supply (L/N) for at least 5
seconds, for example using S2 button according to
the wiring diagram.
• With the BEST SOFTWARE: Click the RESET button
on the ALARMS page.
• Using a Modbus command.
To Next Page
Loading...
Need help?
General
