General notes
The "Maintenance" chapter de-
scribes work involving the check-
ing and replacement of wear
parts that can be performed with
a minimum of effort.
If special tightening torques are
to be taken into account for
assembly, these are listed. An
overview of all required tightening
torques is contained in the
chapter "Technical Data".
Information on additional mainte-
nance and repair procedures is
provided in the repair manual for
your vehicle on DVD, which you
can obtain from your authorized
BMW Motorrad retailer.
Special tools and thorough spe-
cialized knowledge are required
to carry out some of the work
described here. If you are in
doubt, consult an authorized
workshop, preferably your au-
thorized BMW Motorrad retailer.
Standard tool kit
1 Hook wrench
Adjusting the spring
preload on the rear
wheel ( 114).
2 Reversible screwdriver in-
sert
Phillips PH1 and Torx T25
Remove body panels.
Remove battery cover
( 166).
Replacing the light
source for the rear turn
signal ( 158).
3 Open-ended wrench
Wrench size: 10/16 mm
3 Removing battery
( 164).
4 Open-ended wrench
Wrench size: 14
Release/fasten the mirror.
Front wheel stand
Mount front wheel stand
Requirement
The base stand and its acces-
sories are available through your
authorized BMW Motorrad re-
tailer.
Place the Scooter on its center
stand, ensuring that the ground
is level and firm.
Use basic stand with front
wheel mount.
10
136
z
Maintenance
https://www.motorcycle-manual.com/
To Next Page
Loading...
Need help?
General
