Service
Initialization
Initialization must be performed on the panorama glass sunroof anytime the MDS looses
positioning of the glass panels or the headliner or ifthe any component ofthe sunroof
assembly is replaced.
The control button is pressed and held in the position to tilt the sunroof. Initialization
begins approximately 15 seconds after pressing the button. The initialization process may
take over 2 minutes to perform.
Note: The control button MUST be held in the tilt position during the entire
initialization process. Failure to hold the button will result in improper
initialization.
During initialization the panorama sunroof will operate as follows:
• Both sunroof panels enter tilt position(Headliners enter Vent Mode)
• Both Headliners open
• Both sunroof panels lower
• The front sunroof panel opens then closes
• Both Headliners close
Anti-Trapping Protection
Both the covers and the floating headliners are fitted with anti-trap protection. Ifthe MDS
detects something in the path, the appropriate motor is stopped and activated in the
reverse direction.
Service Notes
The motors may be replaced individually. An initialization procedure is required after
replacing one or both ofthe motors
The MDS control unit my be replaced separately. It must although be coded before
initializing.
50
E61 Sports Wagon
To Next Page
Loading...
Need help?
General
