Insert wheel speed sensor in
bore and install screw 1.
Adjust chain tension ( 116).
Chain
Lubricating chain
ATTENTION
Insufficient cleaning and lu-
brication of the drive chain
Increased wear
Clean and lubricate the drive
chain regularly.
Lubricate drive chain at least
every 620 mls (1000 km). Af-
ter driving though water or dust
and dirt, carry out lubricate ear-
lier accordingly.
Switch off ignition and engage
Neutral.
Clean drive chain with suitable
cleaning agent, dry and apply
chain lubricant.
Wipe off excess lubricant.
Check chain sag
Make sure ground is level and
firm and park motorcycle.
Turn the rear wheel until the
position with the lowest chain
sag is reached.
Press chain upward and down-
ward using a screwdriver and
measure difference a.
Chain sag
1.2...1.6 in (30...40 mm) (Mo-
torcycle unloaded on side
stand)
If the measured value is outside
the approved tolerance:
Adjust chain tension ( 116).
9
115
z
Maintenance
To Next Page
Need help?
General
