Danger of overheating
ATTENTION
Engine idling for a lengthy
period while at a standstill
Overheating due to insufficient
cooling; in extreme cases vehicle
fire
Do not allow the engine to idle
unnecessarily.
After starting, ride off
immediately.
Modifications
ATTENTION
Modifications to the motor-
cycle (e.g. engine control
unit, throttle valves, clutch)
Damage to the affected parts,
failure of safety-relevant func-
tions, expiration of warranty
Do not make any
modifications.
Observe checklist
Use the following checklist to
check your motorcycle at regu-
lar intervals.
If there is a change in
the load status
without Electronic Suspension
Adjustment (ESA)
OE
Adjusting spring preload at rear
wheel ( 70).
Adjusting damping on rear
wheel ( 71).
with Electronic Suspension Ad-
justment (ESA)
OE
Setting suspension compliance
( 51).
Always before riding off
Check operation of the brake
system.
Check operation of the lighting
and signal system.
Check clutch function ( 103).
Check tire tread depth
( 106).
Check secure hold of cases
and luggage.
At every third refueling
stop
Check engine oil level ( 96).
Check front brake pad thick-
ness ( 99).
Checking rear brake pad thick-
ness ( 100).
Checking front brake fluid level
( 101).
Check rear brake fluid level
( 102).
Checking coolant level
( 104).
Lubricating chain ( 115).
Check chain sag ( 115).
7
76
z
Riding
To Next Page
Loading...
Need help?
General
