The preconditions for the oil level
check are as follows:
Engine at operating temperat-
ure.
Engine idling for at least ten
seconds.
Side stand retracted.
Make sure the motorcycle is
upright.
The readings mean:
OK: Oil level is correct.
CHECK: Check the oil level the
next time you stop for fuel.
---: Oil level cannot be meas-
ured (conditions as stated above
not satisfied).
If you call up another read-
ing on the on-board com-
puter, this symbol remains visible
until the sensor again registers a
correct oil level.
The most recently measured
level is displayed for five seconds
when you next switch on the ig-
nition.
The oil sensor might be
defective if the "Check oil
level" message reappears even
though the oil level shown by the
oil tank's level indicator is correct.
In this case, consult your author-
ised BMW Motorrad dealer.
Tyre pressure
monitoring RDC
with tyre pressure monitoring
(RDC)
OE
Viewing tyre-pressure
readings
Switch on the ignition.
Repeatedly press button 1 un-
til the tyre-pressure readings
appear on the display.
Tyre-pressure readings 2 are
based on a reference tyre tem-
perature of 20 °C. The front tyre
pressure is on the left; the read-
4
54
z
Operation
To Next Page
Loading...
Need help?
General
