Engage first gear.
Remove five bolts 1 from the
rear wheel, while supporting
the wheel.
If you are using the BMW
Motorrad rear-wheel stand:
remove the retaining disc.
Lower the rear wheel to the
ground and roll it out to the
rear.
If you are using the BMW
Motorrad rear-wheel stand:
reinstall the retaining disc.
Installing rear wheel
Possible malfunctions when
ABS and ASC systems in-
tervene if non-standard wheels
are installed.
See the information on the effect
of wheel size on the ABS and
ASC systems at the start of this
chapter.
Threaded fasteners not
tightened to the specified
torque can work loose or their
threads can suffer damage.
Always have the security of the
fasteners checked by a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
If you are using the BMW
Motorrad rear-wheel stand:
remove the retaining disc.
Roll the rear wheel into position
at the rear-wheel adapter and
attach it.
If you are using the BMW
Motorrad rear-wheel stand:
reinstall the retaining disc.
Fit five bolts 1 and tighten to
the specified torque in diagon-
ally opposite sequence.
Rear wheel to wheel
flange
Tightening sequence: tight-
en in diagonally opposite se-
quence
60 Nm
8
115
z
Maintenance
To Next Page
Loading...
Need help?
General
