ESA setting then automatically
disappears from the display.
Setting load status
Start the engine.
The load status cannot be
set while the motorcycle is
in motion.
Press button 1 to view the cur-
rent setting.
Repeatedly press button 1 until
the setting you want to use
appears on the display.
The display field starts at the
current status and cycles through
the following sequence:
One-up
One-up with luggage
Two-up (with luggage)
The settings shown on the dis-
play are automatically accepted
as the load status and, if ap-
plicable, the riding mode if you
allow a certain length of time
to pass without pressing but-
ton 1. The ESA setting then
automatically disappears from
the display.
Tyres
Checking tyre pressure
Incorrect tyre pressures im-
pair the motorcycle's hand-
ling characteristics and increase
the rate of tyre wear.
Always check that the tyre pres-
sures are correct.
At high road speeds, tyre
valves installed perpen-
dicular to the wheel rim have a
tendency to open as a result of
centrifugal force.
In order to avoid a sudden loss of
tyre pressure, fit a valve cap with
rubber sealing ring to the rear
tyre and make sure that the cap
is screwed on firmly.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Check tyre pressures against
the data below.
Tyre pressure, front
2.5 bar (Tyre cold)
Tyre pressure, rear
2.9 bar (Tyre cold)
4
65
z
Operation
To Next Page
Loading...
Need help?
General
