Ease the brake calipers on to
the brake discs.
Tighten screws 2 on left and
right to the specified tightening
torque.
Brake caliper to slider
tube
30 Nm
Remove the adhesive tape
from the wheel rim.
with BMW Motorrad Integral
ABS
OE
Clip on two retaining clips 1
holding the sensor cable to the
brake line.
The cable of the ABS
sensor could chafe through
if it comes into contact with the
brake disc.
Make sure that the ABS sensor
cable is routed snugly along the
front suspension.
Make sure that the sensor
cable is secured in the retain-
ing clips 3.
Braking efficiency is im-
paired if the brake pads are
not correctly bedded against the
discs.
Before riding off, always check
that the brakes bite as soon as
8
97
z
Maintenance
To Next Page
Loading...
Need help?
General
