the brake lever is pulled or the
brake pedal depressed.
Operate the brake several
times until the brake pads are
bedded.
Removing rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Parts of the exhaust system
can be hot.
Do not touch hot parts of the
exhaust system.
Slacken screw 1 of the clamp
and slip the clamp to the rear.
Do not remove the sealing
grease from the clamp.
Remove screw 2 for the brack-
et of the silencer from the rear
footrest.
Work the end silencer to the
rear to remove and lay it on a
padded rest.
Engage first gear.
Remove axle 1, while support-
ing the wheel.
Roll the rear wheel out toward
the rear.
Install the rear wheel
Possible malfunctions when
ABS and ASC systems in-
tervene if non-standard wheels
are installed.
See the information on the effect
of wheel size on the ABS and
ASC systems at the start of this
chapter.
8
98
z
Maintenance
To Next Page
Loading...
Need help?
General
