Set the clock only when the mo-
torcycle is stationary.
Switch on the ignition.
Press and hold down button 2
until the hours number 3
flashes.
Repeatedly press the button
until the hours number is cor-
rect.
Press and hold down the but-
ton until the minutes number 4
flashes.
Repeatedly press the button
until the minutes number is
correct.
Hold down the button until the
minutes number stops flashing.
This completes the process.
Reading
Select the readings
Switch on the ignition.
Press button 1 to select the
reading in top section of dis-
play 3.
The following values can be dis-
played:
Total kilometres (shown)
Tripmeter 1 (Trip I)
Tripmeter 2 (Trip II)
Warnings, if applicable
with on-board computer
OE
Press button 4 to select the
reading in bottom section of
display 5.
The following values can be dis-
played:
Ambient temperature (°C)
Average speed in km/h
Average consumption in l/
100 km
4
40
z
Operation
To Next Page
Loading...
Need help?
General
