Activating the ABS
function
Press and hold down button 1
until the ABS telltale and warn-
ing light changes status.
ABS telltale and warning
light goes out; if self-
diagnosis has not completed it
starts flashing.
Release button 1 within two
seconds.
ABS telltale and warning
light remains off or contin-
ues to flash.
The ABS function is activated.
You also have the option of
switching the ignition off and
then on again.
An ABS fault has oc-
curred if the ABS telltale
and warning light shows when
the motorcycle accelerates to
a speed in excess of the min-
imum stated below after the
ignition was switched off and
then on again.
min 10 km/h
with riding modes Pro
OE
If the encoding plug is not in-
serted, you have the alternative
of switching the ignition off and
back on again.
Automatic Stability
Control (ASC)
without riding modes Pro
OE
Deactivating the ASC
function
Switching on ignition ( 50).
NOTICE
You have the option of deactiv-
ating the ASC function while the
motorcycle is on the move.
Press and hold down button 1
until the ASC telltale and warn-
ing light changes status.
4
69
z
Operation
To Next Page
Loading...
Need help?
General
