An alarm lasts for approximately
26 seconds. While an alarm is in
progress an alarm tone sounds
and the turn indicators flash. The
type of alarm tone can be set by
an authorised BMW Motorrad
dealer.
with Keyless Ride
OE
The activated alarm can be abor-
ted at any time by pressing the 1
button on the radio-operated key,
without deactivating the anti-theft
alarm.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
The DWA LED then indicates
the reason for the alarm for one
minute.
Light signals issued by the
DWA LED:
Flashes 1x: Motion sensor 1
Flashes 2x: Motion sensor 2
Flashes 3x: Ignition switched
on with unauthorised vehicle
key
Flashes 4x: Disconnection of
the anti-theft alarm from the
motorcycle's battery
Flashes 5x: Motion sensor 3
Deactivation
Kill switch in operating position
(run).
Switch on the ignition.
Turn indicators flash once.
Confirmation tone sounds once
(if programmed).
DWA has been switched off.
with Keyless Ride
OE
Press button 1 on the radio-
operated key once.
NOTICE
If the alarm function is deactiv-
ated by the remote control and
the ignition is not subsequently
switched on, the alarm func-
tion automatically goes active
again after 30 seconds if "Ac-
tivation after ignition OFF" is
programmed.
4
86
z
Operation
To Next Page
Loading...
Need help?
General
