Turn adjusting wheel 1 into
desired position.
The adjustment wheel can
be turned more easily if
you press the handbrake lever
forward when doing so.
Four settings are available:
Position 1: smallest distance
between handlebar grip and
brake lever.
Position 4: largest distance
between handlebar grip and
brake lever.
Start-off assistance
with Hill Start Control
OE
Hill Start Control
Operating
Start-off assistance brake
failure on switching off en-
gine/ignition, folding down side
stand, expiry of time limit (approx.
20 minutes) or in the event of a
fault.
It is imperative to secure the mo-
torcycle by manual braking.
Hill Start Control is only a
convenience system for
easier hill-starting and should,
therefore, not be confused with a
parking brake.
More detailed information
on Hill Start Control can be
found in the section "Technology
in detail".
Apply brake lever 1 firmly and
then release.
Hill Start Control indicator
lamp appears on the dis-
play.
Hill Start Control is now acti-
vated.
To switch off Hill Start Control,
pull brake lever 1 again.
Hill Start Control is auto-
matically deactivated after
pulling away.
The general warning light and
the indicator lamp on the dis-
play light up briefly and then
4
67
z
Operation
To Next Page
Loading...
Need help?
General
