if you have logged on the first
remote control and then do not
press a button within approxi-
mately 30 seconds.
Synchronize the remote
controls
If the central locking system
stops responding to the signals
from a remote control, the unit in
question has to be synchronized.
This can happen, for example, if
the buttons on the remote con-
trol were pressed too frequently
while the remote control was out
of range of the anti-theft alarm.
Synchronize the remote con-
trols as follows:
Switch on ignition.
Press and hold down buttons 1
and 2 until LED 3 stops flash-
ing.
LED 3 flashes for about ten
seconds.
Release buttons 1 and 2.
LED 3 lights up.
Press button 1 or button 2.
LED 3 goes out.
Replacing battery of
remote control
If you press a button on the re-
mote control and the LED does
not show or lights up only briefly:
Replace the battery of remote
control.
Open lid of battery compart-
ment 1.
Dispose of the old battery in
accordance with legal regula-
tions. Do not dispose of the
battery in the household waste.
Using batteries of the
wrong type or inserting
batteries with reversed polarity
can destroy the device.
Use a battery compliant with the
manufacturer's specifications.
When inserting the battery, make
sure that the polarity is correct.
4
75
z
Operation
To Next Page
Loading...
Need help?
General
