flat (battery voltage less than
12 V, indicator lights and mul-
tifunction display remain off
when the ignition is switched
on) always charge the discon-
nected battery with the char-
ger connected directly to the
battery terminals.
ATTENTION
Unsuitable chargers connec-
ted to a socket
Damage to charger and vehicle
electronics
Use suitable BMW chargers.
The suitable charger is
available from your authorised
BMW Motorrad dealer.
With the battery connected to
the vehicle's on-board electrical
system, charge via the power
socket.
NOTICE
The motorcycle's on-board elec-
tronics know when the battery
is fully charged. The on-board
socket is switched off when this
happens.
Comply with the operating in-
structions of the charger.
NOTICE
If you are unable to charge the
battery through the on-board
socket, you may be using a char-
ger that is not compatible with
your motorcycle's electronics. In
this case, directly charge the bat-
tery at the terminals of the bat-
tery that has been disconnected
from the vehicle.
Charging the battery
when disconnected
Disconnecting battery from
motorcycle ( 182).
Charge the battery using a
suitable charger.
Comply with the operating in-
structions of the charger.
Once the battery is fully
charged, disconnect the
charger's terminal clips from
the battery terminals.
NOTICE
The battery has to be recharged
at regular intervals in the course
of a lengthy period of disuse.
See the instructions for caring
for your battery. Always fully re-
charge the battery before restor-
ing it to use.
Connecting battery to motor-
cycle ( 183).
Disconnecting battery
from motorcycle
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
9
182
z
Maintenance
To Next Page
Loading...
Need help?
General
