3.4.6 Service hose and service quick-release
coupling
i When not in use, the service hoses can be wound
up on the side of the ACS 611 and fixated with the
service quick-release couplings.
i Turn the knurled part of the service quick-release
coupling clockwise to open the valve.
Acounterclockwise turn closes the valve.
i To remove the service quick-release couplings from
the holders, press the coupling slightly towards the
connection and carefully pull the knurled section
back to unfasten it from the holder.
3.4.7 Locking brakes
Rolling of the ACS 611 can be prevented by locking the
brakes at the front wheels.
3.4.8 Power cord
! Have the country-specific power cord connected by
a qualified electrician.
i The power cord is firmly connected to ACS 611.
3.4.9 Master switch
Turn the main switch clockwise to turn on the ACS 611.
3.5 Description of function
The refrigerant recovered from the air conditioner
passes through the combo filter to remove suspended
particles and moisture.
The purpose of the vacuum pump is to generate a
vacuum in the air conditioner and to detect possible
leaks in the vehicle air conditioner.
Used oil separated from the recovered vehicle
refrigerant flows into the used oil bottle.
Oil from the fresh oil bottle is used to refill the air
conditioner compressor oil.
The vehicle air conditioner is partly filled with UV dye to
facilitate the detection of leaks in the event of damage
to the vehicle air conditioner.
The refrigerant in the internal refrigerant cylinder is
used for filling the vehicle air conditioner.
The venting unit for non-condensable gases always
takes effect when the vessel pressure is higher than the
saturation pressure.
To Next Page
Loading...
Need help?
General
