Bosch BBS266 User Manual

English – 10
1 270 U20 XBK | (27.03.2019) Bosch eBike Systems
Battery charge indicator
The battery charge indicator of the eBike batteryd
(see "Start page", pageEnglish–13) can be read on
the status page and in the status bar. The eBike bat-
tery's state of charge is also indicated by the LEDs on
the eBike battery itself.
Color of the
indicator d
Meaning
White The eBike battery is over 30 %
charged.
Yellow The eBike battery is over 15 %
charged.
Red The capacity for assisting the drive has
been used up, and assistance is
switched off. The remaining capacity
will be provided for the bike lights and
the on-board computer.
If the eBike battery is being charged on the bike, a
corresponding notification will be displayed.
If the on-board computer is removed from the
holder(5), the state of charge that was last displayed
for the battery is saved.
Setting the assistance level
On the operating unit (7), you can set the level of as-
sistance you want the eBike drive to provide you with
while pedalling. The assistance level can be changed
at any time, even while cycling.
Note: In some models, the assistance level may be
preset and cannot be changed. There may also be
fewer assistance levels available than stated here.
The following assistance levels are available as a max-
imum:
– OFF: Motor assistance is switched off. The eBike
can just be moved by pedaling, as with a normal bi-
cycle. The push assistance cannot be activated at
this assistance level.
– ECO: Effective assistance with maximum efficiency,
for maximum range
– TOUR: Steady assistance, long range for touring
– SPORT/eMTB:
SPORT: Powerful assistance, for mountain biking
and for cycling in urban traffic
eMTB: Optimum assistance whatever the terrain,
rapid acceleration when starting from a standstill,
improved dynamics, top performance (eMTB is
only available in combination with drive units
BDU250P CX, BDU365, BDU450 CX and
BDU480CX. This also requires a software update.)
– TURBO: Maximum assistance even at high pedaling
speeds, for biking sports
To increase the assistance level, press the + (12)
button on the operating unit repeatedly until the de-
sired assistance level appears on the display. To de-
crease the assistance level, press the – (11) button.
The requested motor output appears on the display
h. The maximum motor output depends on the se-
lected assistance level.
If the on-board computer is removed from the holder
(5), the assistance level that was last displayed for
the battery is saved.
Switching the push assistance on/off
The push assistance aids you when pushing your
eBike. The speed of this function depends on the se-
lected gear and can reach a maximum of 3.7mph.
The lower the selected gear, the lower the speed of
the push assistance function (at full power).
u The push assistance function must only be used
when pushing the eBike. There is a risk of injury if
the wheels of the eBike are not in contact with the
ground while using the push assistance.
To activate the push assistance, briefly press the
WALK button on your on-board computer. After acti-
vation, press the + button within 3s and keep it
pressed. The eBike drive is switched on.
Note: The push assistance cannot be activated at as-
sistance level OFF.
EN-91

Bosch BBS266 Specifications

General

Brand	Bosch
Model	BBS266
Category	Bicycle Accessories
Language	English