NOTICE
In case of non-compliance with this safety instruction, material
damage can occur.
3.3
Symbols used
This is a tip.
3.4
Explaining the signal alert symbol on the device
If this symbol is on your device, you have to observe the documentation
on the device. The respective documentation informs on the type of
hazard as well as the steps required to avoid this hazard.
4 Intended use
NOTICE
Risk of damaging the device if not expressly stated accessories,
mounting parts and other components, cables, lines, software
and firmware are used.
The ctrlX CORE control may only be used with the accessories
and mounting parts listed in this documentation. Components
that are not expressly mentioned must neither be attached nor
connected. The same applies to cables and lines.
Only to be operated with the component configurations and com-
binations expressly defined and with the software and firmware
specified in the corresponding functional description.
Typical areas of application of the control:
•
Handling and assembly systems
• Packaging and food processing machines
• Printing and paper converting machines
•
Machine tools
•
Wood working machines
• General mechanical engineering
• Building automation
The ctrlX CORE control may only be operated under the mounting and installation conditions, in the
position of application and under the ambient conditions (temperature, degree of protection, humidity,
EMC, etc.) specified in this documentation.
To Next Page
Loading...
Need help?
General
