SYSTEM SETUP
12
EnglishDeutschEspañolFrançaisItalianoNederlandsSvenska Dansk
Connecting the T1 to an L1 model I power stand
On an L1
TM
model I power stand, the Channel 1 and Channel 2 Mic/Line inputs have independent volume, equaliza-
tion, and ToneMatch
TM
preset controls that can affect the sound of the T1 audio engine. For this reason, the T1
Master output should be connected to either the Channel 3 or Channel 4 Line IN connectors. The R1 remote con-
trol should be disconnected so that the T1 provides the master volume control for the system.
If you want to connect additional sources to the Channel 1 and Channel 2 Mic/Line inputs on the L1 model I power
stand, the R1 remote control must be connected. However, the R1 remote control then will control the master vol-
ume of the L1 system, not the T1 audio engine.
To connect the T1 (as master volume control) to an L1 model I system:
1. Make sure the Power switch on the power stand is in the OFF position and the R1 remote control is discon-
nected.
2. Make sure the T1 power switch is in the OFF position and the T1 audio engine power supply is connected.
See “Connecting the T1 ToneMatch
TM
audio engine power supply (optional)” on page 14 for more details.
3. Make sure the T1 Master volume control is set to 0.
4. Plug one end of a ¼" unbalanced TS audio cable (not supplied) into the T1 Master output port. Plug the other
end of the ¼" cable into the Channel 3 (or Channel 4) Line IN connector on the L1 power stand.
5. Set the Line IN Level control on the power stand to approximately 2.
In some circumstances, you may need to slightly adjust the Line IN Level control from this initial setting to
attain the desired gain structure.
6. Turn on the T1 audio engine.
7. Turn on the L1 model I power stand.
8. Connect your instruments and adjust levels. Refer to “Optimizing input gain and output volume” on page 16.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
