TROUBLESHOOTING AND ROUTINE MAINTENANCE 6 - 16
Packing and shipping the machine
Whenever you transport the machine, use the packing materials that
came with your machine. If you do not pack the machine properly,
you could void your warranty.
Caution
It is important to allow the machine to ‘park’ the print head after a
print job. Listen carefully to the machine before disconnecting it from
the power source to ensure that all mechanical noise has stopped.
Not allowing the machine to complete this parking process may lead
to print problems and possible damage to the print head.
1
Lift the scanner cover from the right-hand side of the machine
until it locks securely into the open position.
2
Remove all the ink cartridges and attach the yellow protective
parts. (See Replacing the ink cartridges on page 6-22.)
Caution
If you are not able to find the yellow protective parts, do NOT remove
the ink cartridges before shipping. It is essential that the machine be
shipped with the yellow protective parts or the ink cartridges in
position. Shipping without them will cause damage to your machine
and may void your warranty.
When attaching the yellow protective parts,
make sure it clips into place as shown in the diagram.
To Next Page
Loading...
Need help?
General
