8
Occasionally, specks of dust or dirt become attached to the machine’s print head and rollers.
This is particularly likely when you are using the unit outdoors or in a very dusty environ-
ment. If a section of the print head is covered with dust, a blank horizontal streak may
appear through the label text. Therefore, as with a tape recorder, the machine’s head may
need to be cleaned from time to time.
To clean the print head and rollers:
1
Turn off the machine.
2
Open the tape compartment cover, then remove the tape cassette if one is installed.
The print head and rollers are located in the tape compartment.
3
Print head: Use a dry cotton swab to gently wipe the print head with an up-and-down
motion.
Rollers: Use a dry cotton swab to wipe each roller with an up-and-down motion while
rotating them with your finger.
4
Install a tape cassette, close the tape compartment cover, and then try printing again.
5
If dust still remains, repeat steps
3
and
4
using a cotton swab dipped in isopropyl
(rubbing) alcohol.
If none of the above works, contact your service representative.
☞
Cleaning can also be done by using the optional print head cleaning cassette (TZ-
CL4).
PRINT HEAD & ROLLERS
Print head
Print head
Rollers
Cotton swab
To Next Page
Loading...
Need help?
General