5
The AC adaptor (model-G) allows you to use this machine wherever there is an electrical
outlet.
To connect the optional AC adaptor:
1
Insert the plug on the adaptor cord into the
connector marked DC IN 7.0V on the right
side of the machine.
2
Insert the plug on the adaptor into the near-
est standard electrical outlet.
☞
Only use the AC adaptor designed
exclusively for this machine.
Remove the batteries and disconnect
the AC adaptor if you do not intend
to use this machine for an extended
period of time. When the power is
disconnected, all text shown in the
display and stored in the memory will be lost.
It is recommended that you use the AC adaptor when printing large fonts on
18 mm-wide tape since this operation can quickly drain the batteries.
A single TZ tape cassette is supplied with this unit. However, since TZ tape cassettes are
available for this machine in a wide variety of colors and sizes, it is possible to make distinc-
tive color-coded and stylized labels.
In addition, this machine has been designed to allow you to change the tape cassettes
quickly and easily.
To change the tape cassette:
1
Lift open the tape compartment cover. The installed cassette is also released.
2
If a tape cassette is already installed, remove it by pulling it straight up.
3
If the ink ribbon in the other tape cassette is loose, use your finger to wind the toothed
wheel in the direction of the arrow on the cassette until there is no slack in the ribbon.
Also, make sure that the end of the tape feeds under the tape guides.
☞
If you are using a new tape cassette provided with a stopper, be sure to remove
the stopper.
OPTIONAL AC ADAPTOR
TAPE CASSETTE
To Next Page
Loading...
Need help?
General