Indicators that appear when “mirror” is selected:
The camcorder has a built-in speaker so you can review the sound track alongside
the picture during playback.
Adjust the speaker volume by turning the selector dial.
• Turn the selector dial up to increase the volume, and down to lower the volume.
• A VOLUME bar appears in the display to indicate the current volume. It
disappears in four seconds.
• You can turn off the built-in speaker completely by turning the selector dial
down until OFF appears.
• You can also adjust the headphones volume separately from the built-in speaker.
(Use the optional DU-200 Docking Unit to connect the headphones, p. 54)
• The levels you adjust for the built-in speaker and headphones are memorized
separately. The camera remembers your levels even if you turn the camera off
and back on again.
Notes:
• The speaker turns off when the camera is set to camera mode or when you use
headphones.
• Sometimes the playback picture becomes rough with “noise”, when the volume
is turned up high. If this happens, turn down the volume.
• These indicators appear normally in the viewfinder.
To Next Page
Loading...
Need help?
General
