49
6
Keep looking at the focusing
point you want to select and
press the shutter button halfway.
s
The <m> icon lights in the
viewfinder.
s
The AF point you look at will flash in
red and focus the subject.
7
Take the picture.
• If the camera fails to detect which AF point you are looking at, the <m> icon
in the viewfinder will blink and automatic AF point selection will take effect.
• If Eye Control does not work well, check if you are using the correct CAL No.
and see “Eye Control Calibration and Operation Tips” on page 46.
Eye Control Servo AF
When you use Eye Control in the AI Servo AF mode (or AI Focus AF set
to AI Servo AF), you can focus a moving subject continuously just by
looking at it. This is called Eye Control Servo AF.
If the subject focused with Eye Control starts to move, you can continue
to focus-track the subject with your eye by looking at the next AF point
covering the subject while holding down the shutter button halfway.
Turning Off Eye Control
Tu rn the Eye Control switch to <2>.
The AF point can then be selected
automatically or manually.
To Next Page
Loading...
Need help?
General
