0SCJ-04U
Printing Specific Pages onto Different Paper
You can print specific pages of a document, such as when you want to print the cover of a booklet on colored
paper. In this case, load colored paper for the cover in the manual feed slot and load plain paper for the body
pages in the paper drawer, and then specify the paper settings on the printer driver.
[Paper Source] tab
Select the pages to print on different paper and the paper source loaded with the paper from [Paper
Selection]
[OK]
[Paper Selection]
Specify which pages should be printed on different paper, and select which paper source should be used to feed paper for
each page.
[Same Paper for All Pages]
Prints all of the pages on the same paper, and does not print any specific pages on
different paper. All the pages are printed on paper specified in [Paper Source].
[Different for First, Others,
and Last]
You can use different paper for the first page, body pages, and last page, respectively. For
example, you can specify the paper in the manual feed slot for [First Page], the paper in
the paper drawer for [Other Pages] (body pages), and the paper in the manual feed slot
for [Last Page]. Also, selecting [Paper Type] in [Select by] enables you to specify the
paper type used for printing rather than the paper source.
[Different for First, Second,
Others, and Last]
You can also specify the paper for the following page of the cover as well as specifying the
paper in [Different for First, Others, and Last]. Also, selecting [Paper Type] in [Select by]
enables you to specify the paper type used for printing rather than the paper source.
[Different for Cover and
Others]
Specify the settings for booklet printing (
Printing Booklet (MF729Cx / MF728Cdw /
MF724Cdw)). You can specify different paper for the cover and body pages, respectively.
For example, you can specify the paper in the manual feed slot for [Cover Page] and the
paper in the paper drawer for [Other Pages] (body pages).
[Transparency Cover
Sheets]
If you perform continuous printing on transparencies, the output transparencies may stick
together. To prevent this, print alternately on transparencies and paper in the order of
Transparency, Paper, Transparency, Paper, and so on. The paper that is inserted between
transparencies is called a "cover sheet." Make sure to specify both the paper source loaded
with transparencies and the one with cover sheets. Select the [Print on Cover Sheets]
check box to print on both transparencies and cover sheets in the order of placed
documents.
LINKS
Printing a Document
㻞㻝㻡㻌㻛㻌㻣㻟㻡
To Next Page
Loading...
Need help?
General
Weight and Dimensions
