*1: The object name you have specified in Name is displayed in Printer Setup Utility (or Print Center ) in Mac OS
X 10.2.8–10.4. If you use multiple printers in the same zone, assign a unique name to each printer. By default,
the network interface name is Canon NB-18GB (xxxxxx). (Here, xxxxxx is the last six digits of the printer's
MAC address.)
*2: If zones have been created on the network, enter the name of the printer's zone. If there are no zones, leave the
asterisk * entry (for the default zone) as it is. If you enter a network zone name that does not match created
zones, the printer will not be detected by Macintosh computers. Consult your network administrator for informa-
tion on zone names.
7. Click OK to display the Network page.
Configuring the Destination for AppleTalk Networks
To print over an AppleTalk network, activate the AppleTalk protocol and configure the destination as follows.
Activating AppleTalk on the printer
Important
• By default, the AppleTalk protocol is disabled on the printer.
1. On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to select the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press â–² or â–¼ to select Interface Setup, and then press the OK button.
4. Press â–² or â–¼ to select AppleTalk, and then press the OK button.
5. Press â–² or â–¼ to select On, and then press the OK button.
Network Setting
>
Network Setting (Mac OS X)
>
Configuring the Destination for AppleTalk Networks iPF6300
9
892
To Next Page
Loading...
Need help?
General