Canon MVX330i User Manual

104
Selecting the Focusing Point
The subject you wish to record is not always in the center of the screen. In the Focus-
Priority mode, you can choose from one of three focusing points to automatically put the
subject you wish into sharp focus.
When the program selector is set to EASY, the Focus-Priority becomes set to ON (only
the center focusing point is available).
1. Set the program selector to .
2. Turn the SET dial to display all focusing frames.
Three focusing frames appear on the screen, one of it in green.
3. Turn the SET dial to select the focusing point.
Turn the SET dial up to select the frame to the right, down to select the frame to the
left.
 The focusing frame gives an indication of the focusing point. Depending on the
size of the subject or the distance, the camcorder may focus outside the frame.
 When you operate the zoom lever, the frames other than the selected one
disappear.
 The focusing point can be selected only when Focus-Priority is set to [ON] in
CARD CAMERA mode.
 The focusing point returns to the center if you turn off the camcorder, change
from CARD CAMERA mode or move the program selector to EASY.
 The focusing point cannot be selected in the following cases:
- When using the digital zoom.
- When exposure is locked.
- In Stitch Assist mode.
Turning Off the Focus-Priority Mode
Turn off the Focus-Priority mode if you wish to put timing ahead of focus.
Open the menu and select [CAMERA SETUP]. Select [FOCUS PRI.], set it
to [OFF] and close the menu.
CAMERA
PLAY (VCR)
CARD CAMERA
CARD PLAY
CAMERA
PLAY (VCR)
CARD CAMERA
CARD PLAY
MENU
(37)
CAMERA SETUP FOCUS PRI. ••• ON

Canon MVX330i Specifications

General

Digital zoom	360 x
Optical zoom	18 x
Image stabilizer	Yes
Focal length range	45.4 - 817 mm
Sensor type	CCD
Total megapixels	1.33 MP
Optical sensor size	1/4.5 \
Display diagonal	2.5 \
Resolution	1280 x 960 pixels
Minimum illumination	0 lx

Weight and Dimensions

Depth	78 mm
Width	72 mm
Height	131 mm
Weight	500 g