8400-0181-OM Rev C 185 and 185B Installation & Technical
27
PIECE COUNTING
The piece-counting feature can be used to convert weight into the number of pieces on the
scale.
NOTE: This function is not available when LFt=yes (Legal-For-trade) and USA=YES
(Domestic) has been selected in setup.
To enter count mode:
1. Press the Fn/▲ key twice.
2. If the average piece weight has been previously calculated, the display will show
the number of pieces on the scale.
3. If an average piece weight has not been previously calculated, the display will
change to Add= 5.
4. To change the sample size, press the Fn/▲ key repeatedly to scroll through the
following sample sizes: 5, 10, 25, 50, and 75.
5. Alternatively, press the UNITS/◄ key and a digit will begin to flash. Press the
Fn/▲ key to change the digit. Press the UNITS/◄ key to select a different digit to
change.
6. Add the selected quantity of pieces to the scale and press the TARE key.
7. The average piece weight will be calculated and the display will change to show
the count of pieces on the scale.
To calculate a new average piece weight:
1. Press the Fn/▲ key.
2. The display will change to Add= 5.
3. To change the sample size, press the Fn/▲ key repeatedly to scroll through the
following sample sizes: 5, 10, 25, 50, and 75.
4. Alternatively, press the UNITS/◄ key and a digit will begin to flash. Press the
Fn/▲ key to change the digit. Press the UNITS/◄ key to select a different digit to
change.
5. Add the selected quantity of pieces to the scale and press the TARE/Enter key.
6. The display will change to show the count of pieces on the scale.
Press the PRINT key to transmit the number of pieces through the serial port.
Press the NET/GROSS key to return to weight display mode.
To Next Page
Loading...
Need help?
General
