Carrier GC Series User Manual

44
4. Reinstall the removed plastic plugs in the original Conden-
sate Drain Location.
5. Route the flexible plastic tube from FRONT left corner post
to BACK left. See Fig. 37.
CAUTION
!
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Avoid kinking the hose and/or creating a dip which could
act as a second internal p--trap. Double trapped drain lines
will not drain properly.
6. Measure and cut the condensate drain hose to the
appropriate length.
7. Insert spring onto condensate drain hose.
8. Reinstall condensate drain plastic fitting and bushing in its
new location. See Fig. 38.
A14093
Fig. 37 -- Route Plastic Tube from Front Left to Back Left
A14091
Fig. 38 -- Relocate Condensate Drain Connection
HRP Switch Relocation
The HRP Pump Disconnect Switch is mounted on front right
corner post. See Fig. 39.
A14094
Fig. 39 -- HRP Pump Disconnect Switch Location
!
WARNING
PERSONAL INJURY AND/OR UNIT DAMAGE
HAZARD
Failure to follow this caution may result in personal injury
and/or wire damage.
Do not route wiring over potentially hot surfaces or
exposed sharp edges.
A14095
Fig. 40 -- Rectangular Knockout Location

Carrier GC Series Specifications

General

Brand	Carrier
Model	GC Series
Category	Heat Pump
Language	English