Controlling the Sound of a Performance
EN-33
You can use the procedure below to adjust the volume level of the main tone and layer tone.
1.
While holding down FUNCTION, press the A3 or B3 keyboard key.
• Do not release FUNCTION until step 2, below.
2.
Use keyboard keys C4 through E5 to set the volume level.
• You can specify a volume value from 0 to 127.
• Each press of the + or – keyboard key changes the volume value by 1. Long-pressing either of
these keyboard keys scrolls the setting value.
• You can use keyboard keys 0 to 9 to enter a specific volume value.
Examples:
– To set a volume of 20, press 2, then 0. The volume setting will not change until you release
FUNCTION in step 3, below.
– To set a volume of 120, press 1, then 2, then 0. In this case, the volume value will change
as soon as you input the third digit.
• To return the setting to its initial default, press the – and + keyboard keys at the same time.
3.
Release FUNCTION.
Adjusting the Volume Level of Each Part
C7
A3 (Main part)
B3 (Layer part)
0123456789
＋−
D4
C{4
C4 E4 F4 G4 A4 B4 C5 D5 E5
E}4
To Next Page
Loading...
Need help?
General
