119
3.6.2 Laser Scanner Reading
This function only applies to models equipped with a laser scanner (1D).
After a barcode is scanned, the scanning result is output.
Operating procedures
Select Start -> Programs -> Utilities -> Laser scanner reading.
1. Start laser scanner reading
The starting icon (
) is displayed in the task tray.
2. Start the application
Start the application that receives the scanning result.
3. Start scanning
Press the Trigger key to start scanning.
4. End scanning
Scanning will end when the Trigger key is released, or when the timeout time elapses.
The scanning result will be output to the application.
[Remarks]
i To exit the laser scanner application, click the icon in the task tray and then select Exit from
the menu.
ii Output to clipboard copies the scanning result data to the clipboard, to be pasted (with a
“Ctrl+v” keyboard event). Therefore, scanning result data output is not possible with
applications that do not support paste operation.
iii Laser scanner scanning cannot run at the same time as another application that uses the
scanner (such as Laser Demo).
To Next Page
Loading...
Need help?
General