97
3.2 Perform Initial Setup
3.2.1 Welcome Wizard
(1) Startup screen
After the terminal first boots, the following Startup screen will appear. The following settings can be
made from here:
Touch panel calibration
Owner information
Date and time
Execution
operation
Explanation
Tap the screen 1. Changes to the Touch Screen Position Calibration screen. Finish
touching the five points, then
Press the Enter key to save the setting content.
(Refer to “3.3.2 Touch Panel Calibration” for details)
2. Next, the Settings screen for “Owner Information -> Date/Time” is
displayed.
Press the Skip
button
2. Next, the Properties screen for “Owner Information -> Date/Time” is
displayed.
[Remarks]
[1] Refer to “3.2.2 Date/ Time/ Alarm Setting” for details of “Date/Time”.
[2] Refer to “3.2.3 Owner Information” for details of owner information.
[3] However, everything must be reset in the event of a full reset of the terminal.
To Next Page
Loading...
Need help?
General