121
3.7 Imager (2D) Settings
This function only applies to models equipped with an imager (2D). Refer to Chapter 2, “2.10
Imager (1D/2D codes, postal codes)” for details of this function.
3.7.1 Imager Settings
Select Start -> Settings -> Control Panel - Imager Setting.
Use the dialog below to change CMOS imager device settings.
［1D］Tab ［2D］Tab
Tab Item Explanation
1D
All
Specify the 1D code to read.
Multiple symbologies can be specified.
2D
All
Specify the 2D code to read.
Multiple symbologies can be specified.
To Next Page
Loading...
Need help?
General