Casio DT-X200-10E User Manual

45
2.9.3 Scanning conditions
Conditions that allow scanning a barcode symbology in specific modes can be set for each
readable symbology.
Readable symbology codes
Barcode symbologies that are enabled or disabled for scanning can be specified.
If only specific symbologies are to be scanned, set “Enable” for scanning on these barcode
symbologies only and “Disable” on the other symbologies. This will reduce decode processing
time and lower the error rate. The default is “Enable scanning of all symbologies”.
Readable digits
The no. of digits to read can be set for each readable symbology.
If only a specific no. of digits is to be scanned, specify it for each readable symbology. This will
reduce decode processing time and lower the error rate.
Enable or disable check digit
Check digit can be set to “Enable” or “Disable” for each readable symbology.
Enabling check digit will lower the error rate.
Barcode Check digit calculation
Check digit calculation
default
EAN, JAN, UPC-A Valid Valid
EAN, JAN, UPC-A add-on Valid Valid
UPC-E Valid Valid
UPC-E add-on Valid Valid
Code39 Enable/ disable Disabled
NW-7 Enable/ disable Disabled
Interleaved 2 of 5 Enable/ disable Valid
Industrial 2 of 5 Enable/ disable Valid
Code93 Valid Valid
Code128
*1
Valid Valid
MSI Valid Valid
IATA Enable/ disable Disabled
GS1 DataBar (Omnidirectional,
Truncated)
(RSS-14 (Truncated))
Valid Valid
GS1 DataBar Limited
(RSS Limited)
Valid Valid
GS1 DataBar Expanded
(RSS Expanded)
Valid Valid
GS1 DataBar Stacked (Omnidirectional)
(RSS-14 Stacked (Omnidirectional))
Valid Valid
GS1 DataBar Expanded Stacked
(RSS Expanded Stacked)
Valid Valid

Casio DT-X200-10E Specifications

General

Brand	Casio
Model	DT-X200-10E
Category	Handhelds
Language	English