Compass Operation
Mirror Operation
The right side
of
the switch located at the bottom
of
the
mirror turns the electrochromic mirror on and
off.
The
AUTO LED will come on when the electrochromic mirror
is turned on. To
turn
the mirror
on,
press and hold the
MIRROR
button for three seconds. The mirror will darken
and remain dark until the button
is
released.
To
turn
the
mirror
off,
press and release the MIRROR button.
Press
COMP
to turn the compass on
or
off.
When the ignition and the compass feature are on, the
compass will show two character boxes for
approximately two seconds. After two seconds, the
mirror will display the compass heading.
When cleaning the mirror, use a paper towel or similar
material dampened with glass cleaner.
Do
not spray
glass cleaner directly on the mirror as that may cause the
liquid cleaner to enter the mirror housing.
Compass Calibration
If
after two seconds the display does
not
show a
compass heading
(“N”
for
North,
for example), there
may be a strong magnetic field interfering with the
compass.
Such
interference may be caused by a
magnetic antenna mount, magnetic note pad holder or
a
similar magnetic item.
If
the letter
“C”
should ever
appear in the compass window, the mirror may
need calibration.
The mirror can be calibrated
in
one
of
two ways:
0
Drive the vehicle in circles at five mph
(8
kmh) or
less until the display reads a direction,
or
0
Drive the vehicle on your everyday routine.
2-45
To Next Page
Loading...
Need help?
General
