To replace the battery:
Synchronization
Synchronization may be necessary due to the security
method used by this system. The transmitter does not
send the same signal twice to the receiver. The receiver
will not respond to a signal it has been sent previously.
This prevents anyone from recording and playing back
the signal from the transmitter.
To
resynchronize your transmitter, stand close to your
vehicle and simultaneously press and hold the
LOCK
and
UNLOCK
buttons on the transmitter for at least five
seconds. The door locks should cycle to confirm
synchronization. If the locks do not cycle, see your
dealer for service.
1.
2.
3.
4.
Insert a small coin, or flathead screwdriver, to
separate the bottom
of
the transmitter from the top.
Remove the battery and replace it with a new one,
making sure the positive
(+)
side of the battery
is
facing down.
Snap the top and bottom together.
Test the operation of the transmitter with your
vehicle. If the transmitter does not work, try
synchronizing the transmitter with the receiver.
Your
Doors
and
How
They
Work
Side
Doors
To
open the door from the outside, pull the handle up
and pull the door open.
To open the door from the inside, pull the lever toward
you and push the door open.
2-8
To Next Page
Need help?
General
