Folding the Second Seat (Suburban)
If your vehicle has a
60/40
rear seat, either side may be
folded down to give
you
more cargo space.
Before folding, place the latch portion
of
the center
safety belt in the center armrest. That way, the center
safety belt will be out of the way when the seat is folded
and also will be easily available for passengers to use
when the seat is returned to the passenger position. Also,
make sure that nothing is under or in front of the seat.
When the seat is folded, it will lay flat on the floor.
When folding the seat, first
remove the head restraints.
Push the release buttons at
the bottom
of
each head
restraint height-adjust
post and slide the head
restraint
out
of the
height-adjust tubes.
Set the head restraints aside for now.
You
will stow
them in their proper positions after you are done folding
the seat.
To fold the seat, pull up on
the strap loop at the rear
outer edge
of
the seat
cushion. Then, pull the seat
cushion up.
After folding the seat cushion forward, push down on
the lever at the side
of
the seatback and fold the seatback
forward until it is flat.
Then, stow the head
restraints by sliding them
into the rear of the seatback.
Make sure the posts go in
all the way.
To Next Page
Loading...
Need help?
General
