To
fold the seat, pull up on
the strap loop at the rear of
the seat cushion.
Then, pull the seat cushion up and fold it forward.
After folding the seat cushion fully forward, pull
the seatback forward and fold the seatback down
until
it is flat.
Then, stow the head
restraints by sliding them
into the rear of the seatback.
Make sure the posts go
in
all the way.
To
return the seat to the passenger position, first remove
the head restraints by sliding them
out
of
the seat cushion.
Lift the seatback up and push rearward
all
the way. Then,
lower the seat cushion until it latches in position.
After returning the seat to the passenger position, return
the head restraints to the top
of
the seatback. Pull
forward on the seatback and up on the seat cushion
to
make sure that the seat is securely in place.
If the latch plate portion
of
the center safety belt was put
in the center armrest when the seat was folded, take the
latch plate portion out and place
it
on the seat. That way,
the center position safety belt will be available for the
center rear seat passenger to use.
1-11
To Next Page
Loading...
Need help?
General
