3.
Unplug the
electrical connector.
4.
Turn the bulb to the left and remove it.
5.
Put the new bulb into the lens assembly and
turn
it
to
the right until it
is
tight.
6.
Plug in the electrical connector.
7.
Put the headlamp lens assembly back
into
the
vehicle. Install and tighten the two screws.
Front Parking/-rn Signal Lamps with
Sealed Beam Headlamps
1.
Remove the two screws
at the inside edge of
the parkinghurn signal
lamp assembly.
2.
Remove the lamp assembly by swinging it out from
the inside edge and sliding
it
out at the outside edge.
6-39
To Next Page
Loading...
Need help?
General
