Follow these instructions to lower the spare tire:
1.
One side of the ratchet has an
UP
marking. The other
side has a DOWN marking. Assemble the ratchet
to the hook near the end of the jack handle (as
illustrated) with the DOWN marking facing you.
Insert the other end through the hole in the rear
bumper and into the hoist shaft.
2.
Turn the ratchet
to
lower the spare tire to the ground.
Continue to turn the ratchet until the spare tire can be
pulled out from under the vehicle.
3.
When the tire has been lowered, tilt the retainer at
the end of the cable
so
it can be pulled up through
the wheel opening.
4.
Put the spare tire near the flat tire.
If your two-door utility
model has a jack cover,
turn the wing nut
counterclockwise and
take the cover
off.
To take the jack out, turn the wing nut counterclockwise
and take it and the retainer off. Take the jack and storage
box out and take the tools out of the box.
Your vehicle may have a pair of emergency gloves
secured
to
the jack.
You
can use them when changing
the tire, or during other emergency situations.
Remember to replace them with the jack,
so
you will
have them
if
needed later.
5-24
!
To Next Page
Loading...
Need help?
General
