CHAPTER 3
Install and Connect the Router
This chapter describes how to install and connect Cisco 1000 Series Integrated Services Router (ISR) to LAN
and WAN networks.
Read the installation instructions before using, installing or connecting the system to the power source.
Statement 1004
Warning
Installing the Cisco 1000 Series Integrated Services Routers involve these tasks:
• Unpack the Router, on page 23
• Set up Router on Desktop, Rack, or Wall, on page 23
• Connect Power Cable, on page 34
• Connect the Router to a Console, on page 34
• Connect WAN and LAN Interfaces, on page 37
• Configure the Router at Startup, on page 39
Unpack the Router
Unpack the router only when you are ready to install it. If the installation site is not ready, to prevent accidental
damage, keep the chassis in its shipping container until you are ready to install.
The router, accessory kit, publications, and any optional equipment you order may be shipped in more than
one container. When you unpack the containers, check the packing list to ensure that you have received all
listed items.
Set up Router on Desktop, Rack, or Wall
After unpacking, based on your requirements, you can set up a Cisco 1100 Series Integrated Services Routers
(ISRs) on a desktop, a rack, or the wall.
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
23
To Next Page
Loading...
Need help?
General
