Insert a Micro-SIM Card
This section describes how to insert a Micro-SIM card into an LTE pluggable module.
Do not touch any part of the exposed PCB circuit area when the Micro-SIM cover is removed.
Caution
Figure 28: Insert the Micro-SIM cards
DescriptionItem
Micro-SIM 1 (Towards the device)1
Micro-SIM 0 (Away from the device)2
To insert the Micro-SIM cards into the LTE Pluggable module:
1. Place the router on its bottom side, remove the screws and then the Micro-SIM cover from the pluggable
module.
2. Push in each Micro-SIM card into the slot until it clicks.
3. Secure the Micro-SIM cover with a screw. The recommended torque is 2.8 - 3.8 inch LBF.
You have now successfully inserted the Micro-SIM cards into the LTE pluggable module.
Remove and Replace the 1GB Flash Token Memory Stick
The Cisco 1100 Series ISR has a port for 1 GB flash token memory stick to store configurations or Cisco IOS
XE consolidated packages.
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
49
Install and Upgrade Internal Modules and FRUs
Insert a Micro-SIM Card
To Next Page
Loading...
Need help?
General
