Cisco ASR 1000 Series Configuration Guide

PurposeCommand or Action
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Specifies a web-cache or dynamic service to enable on the
router, specifies a VRF-name to associate with the service
ip wccp [vrf vrf-name] {web-cache | service-number}
[group-address multicast-address] [redirect-list
Step 3
group, specifies the IP multicast address used by the service
access-list] [group-list access-list] [password
password [0 | 7] ]
group, specifies any access lists to use, specifies whether to use
MD5 authentication, and enables the WCCP service.
Example:
Device(config)# ip wccp web-cache password
password1
Targets an interface number for which the web cache service
will run, and enters interface configuration mode.
interface type number
Example:
Device(config)# interface ethernet0/0
Step 4
Enables packet redirection on an outbound or inbound interface
using WCCP.
ip wccp [vrf vrf-name] {web-cache | service-number}
redirect {in | out}
Step 5
Example:
Device(config-if)# ip wccp web-cache redirect
in
•
As indicated by the out and in keyword options,
redirection can be specified for outbound interfaces or
inbound interfaces.
Exits interface configuration mode.exit
Example:
Device(config-if)# exit
Step 6
Targets an interface number on which to exclude traffic for
redirection, and enters interface configuration mode.
interface type number
Example:
Device(config)# interface GigabitEthernet
0/2/0
Step 7
IP Application Services Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 1000)
65
Configuring WCCP
Configuring WCCP

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English