Cisco ASR-920-4SZ-D User Manual

PurposeCommand or Action
Sets the revision level of the MSTP region.
revision revision -number
Example:
Device(config-mstp)#)revision 1
Step 6
Returns to privileged EXEC mode.end
Example:
Device(config-mstp-if)# end
Step 7
Configuring untagged EFP over MST interface
Describes steps to configure untagged EFP over MST:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface number
4.
no ip address
5.
service instance number ethernet [name]
6.
bridge-domain bridge-id
7.
encapsulation untagged dot1q {any|vlan-id [,vlan-id [-vlan-d]]}
8.
l2protocol peer stp
9.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Example:
Router> enable
Step 1
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Specifies the Gigabit Ethernet interface to configure, where:
slot/subslot/port-Specifies the location of the interface.
interface interface number
Example:
Router(config)# interface gigabitEthernet 0/0/5
Step 3
LAN Switching Configuration Guide Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
71
Multiple Spanning Tree Protocol
Configuring Multiple Spanning Tree Protocol

Cisco ASR-920-4SZ-D Specifications

General

Brand	Cisco
Model	ASR-920-4SZ-D
Category	Network Router
Language	English